hoe to select the cable size in sq mm for certain load?
Answer Posted / pradeep bandre
AS WE KNOW CABLE CORE IS MADE UP OF ALLUMINIUM.AND IF
RESISTIVITY OF ALUMINIUM IS 'D' AND ARAEA OF CROSS-SECTION
IS 'A' THEN RESISTANCE=D(L/A) WHERE 'L' IS LENGHTH OF
CABLE.THEN BY FORMULA I=V/R YOU CAN CALCULATE THE CURRENT
CAPACITY.
Is This Answer Correct ? | 4 Yes | 8 No |
Post New Answer View All Answers
1. Why is the speed of shunt motor practically constant? 2. Why dc series motor use to start with heavy loads? 3. advantages & disadvantages of separately excited generator over self excited generator?
Give some differences between open loop and closed loop control systems.
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
Draw torque - speed curve and load curve of induction motor? mark operating point ?
Is Transol transformer oil comparable to nynas nytro libra?
what is the use of permanent magnet generator in exciter
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
Why to keep capacitor bank off while generator running.
How do i carry out or know the vector group of a Dyn1 and Dyn5 transformer
how to test reverse power trip?
How shall i select the value of capacitor or inductor in a system?
What is bridge rectifier and explain with details
How to calulate Locked rotor amper(LRA) for compressor type motors?
What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)
What is a surge supressor why its is used in synchronous generators