Answer / rajesh kumar

We can select the cable size in sqmm for certain load by
this process
Cross sectional area of conductor in sqmm
In single phase=a=2x4.59PL
Where a=crosssectional area of conductor
P=Load in KW
L=Distance of load point

In three phase=a=4.55xPL/3

Answer / swaroopreddy

skin effect by current carrying conduter mainly decides the
carrying capacity of cable,

Answer / simon

Wt=P=v*I find the amp cap of load.

Answer / pradeep bandre

AS WE KNOW CABLE CORE IS MADE UP OF ALLUMINIUM.AND IF
RESISTIVITY OF ALUMINIUM IS 'D' AND ARAEA OF CROSS-SECTION
IS 'A' THEN RESISTANCE=D(L/A) WHERE 'L' IS LENGHTH OF
CABLE.THEN BY FORMULA I=V/R YOU CAN CALCULATE THE CURRENT
CAPACITY.

Answer / sanjeet swarnakar

by kelvins law we can calcute the economical size of the
conductor

In AC Drives How can change & control its output Frequency?

5 Answers   Jindal,

What are the basic components of the feedback control system?

0 Answers  

Why the transformers are rated in KVA ? in new view

3 Answers  

What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?

0 Answers  

What does CDG,CDAG,CAG,VAJ,VAJH,VTT,VAZ,VAA etc. stands for in case of relays and can anyone answer to decode this codes C,V,D,G,A,X,TT,J,JH etc

4 Answers   HNL,

what is the std. earthing resistance for 440V system or m/c, 33000/440 Volt substation? What is the std.?

2 Answers  

why there is a phase shift lies between primary and secondary voltages of a transformer?

7 Answers   Mecon,

what is formula for zero phase sequence of nuetal earthing transformer of 6.6 kv

0 Answers  

where can i get vijaya electricals limited in hyderabad interview auestions can u give me the website address plz

0 Answers  

how you taken aotitude test

0 Answers  

HT and LT cables can be laid on same cable tray

1 Answers  

i am electrical engineer i cant get job in pure electrical industry ,but i got job in instrumentation field whether there is good scope for me, as i am fresher i m not well with the industrial trends so any experienced engineer pls reply me

2 Answers