What are methods to avoid the inrush current at the time of
starting of power transformer ?
- 8 Answers
- 11448 Views
- Wipro, I also Faced
- E-Mail Answers
Answer Posted / vinothbabu.k
BRFORE STARTING ON THE TRANSFORMER WE SHOULD SWITH OFF ALL
THE OUTGOING FEEDER FROM THE DISTRIBUTED PANEL BOARD,THEN
ON THE TRANSFORMER WITHOUT CONNECTING ANY LOAD, THEN SWITH
ON THE FEEDER ONE BY ONE,R CONNECTED LOAD.THIS THE METHOD
TO AVOID THE INRUSH CURRENT FROM THE TRANSFORMER...
| Is This Answer Correct ? | 13 Yes | 4 No |
Post New Answer View All Answers
what is the difference between oil surge relay and buchholz relay.
How CFL &T5 tube light glows?
what is the criterion for selecting vector group of Transformers ? i mean how to decide vector group of Generator transformer, substation trasformer and transformer at consumer end
What is the difference between line drop and percentage line drop?
What is servo motor? what is its purpose?
what is capacitor voltage transformer?? how it is different from potential transformer?
What is the effect of atmospheric pressure & Temp; on efficiency of motor? Why NGR(Neutral Grounding Resistor) is used in 132/11 KV Transformer & how? What is the use of Auto T/F in Grid Station?
Why it need to form a capcitor when it not been in use from three or two year. Plz describe it technically.
how to calculate the earth mat design in 132 kv substation yard ????
Why negative feedback is preferred in the control system?
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
what is the difference between c power and U power acb breaker
hello if any one have papers vof hpcl or sail, plz send me
When distance between two pulleys is not fixed, the tension of belt is adjusted by a) driver shaft b) driven shaft c) adjustment screw d) belt
what is meant by impulse voltage?
