What are LEAFs ?

2236

In sesame, the one-pod condition (P) is dominant to the three-pod condition (p), and normal leaf (L) is dominant over wrinkled leaf (l). The two characters are inherited independently. Determine the genotypes and phenotypes of the two plants which produce the following progeny: 318 one- pod normal, 98 one-pod wrinkled, 323 three-pod normal and 104 three-pod wrinkled.

5102

You have been provided with a set of plates of fungi isolated from a diseased leaf, one Chytridiomycota, one Zygomycota, one Ascomycota and one Basidiomycota. The signs of infection indicate that the disease has been caused by a member of Ascomycota which does not form a sexual stage easily. What features would you look for in your isolates to indicate if the target fungus was present?

1486

What is the relation between how fast a leaf burns and the minerals or metallic elements contained in the plants?

1523

Explain the leaf anatomy of eucalyptus?

1545

Does time affect the stomata density of a leaf e.g young leaves, old leaves.?

1565

what are the no. of leaf nodes in a fibonacci tree ?

1931

AS PER THE AP VALUE ADDED TAX ACT 2005 LEAFLET 14 VIDE ITEM (1)(A) IF AN AGENT SELLS ANY GOODS ON BEHALF OF THE AGRICULTURIST PRINCIPAL HE IS UNDER NO OBLIGATION TO OBTAIN REGISTRATION UNDER THE AP VAT ACT. BUT AFTER ADDITION OF SUB SECTION 10(a) UNDER SECTION 4 WHAT IS THE POSITION OF AGENT WHO SELLS GOODS ON BEHALF OF AGRICULTURIST PRINCIPAL. IS IT NECESSARY FOR HIM TO OBTAIN REGISTRATION UNDER THE APVAT ACT. PLEASE CLARIFY?

1700

2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand

1814

what is the height of tree if leaf node is at level 3. please explain

1613

in b+ trees, all the data is stored in leaf nodes. if all leaf nodes are crashed then how to get/recovery the data back?

1523

Write the algorithm to check the number non-leaf nodes in a tree.

611

What is thymeleaf template?

157

Why do we use thymeleaf?

160

What is thymeleaf template engine?

170