what is difference b/w tube and pipe ?

6 Answers   BSL, Descon, Kirloskar,

---

Explain about safety integrated level protection? . How it was differ from other protections ?

0 Answers  

---

I have observed in field instrumentation work... I remove the fuse of an analog transmitter then it shows 7.75 kg/sq cm (which is practically wrong value)in DCS and when put the fuse it shows 0 in dcs. Then cheach the field transmitter termination and found moister. clean that and then it shows 1.1 kg/ sq cm which is right value. Please describe the above phenomenon.

1 Answers  

---

Condensation within a sight glass? Would you expect there to be more problems when using a sight glass if there is condensation on the inside or the outside of the glass, and why?

1 Answers  

---

What is meant by GAP VOLTAGE, in vibration measurement. Normally how much GAP VOLTAGE is set and state the reason.

3 Answers   ADMA OPCO,

---

---

what is difference between E/P positioner and I/P positioner. Why E/P fixed in below actuator and why I/P fixed in other place

1 Answers  

---

how can calibrate transmitter online

2 Answers  

---

why is honed type flow orifice plate? what purpose it used? how to select this?

4 Answers  

---

WHAT IS D/O D/I AND A/O A/I PLZ EXPLAIN

2 Answers  

---

What is the standard height for stancion supports?

4 Answers  

---

whats diffeence between dcs & scada operation.

3 Answers   Orchid, Reliance,

---

what is radar type level transmitters and its basic principle and how to calibrate it

4 Answers   ABB, Inovonz,

---