Answer / kranti1986

to create pressure difference in a flow line. withe the pressure difference we can measure the flow rate

Which products are available in the Mass Systemswitch and System Manager AC range?

0 Answers  

---

we are using centum vp as monitoring with Dell precision work station T3600 but some times PC(s) are restarted automatically . how we can solve this problem? thanks

0 Answers   Oil India,

---

How can we cheak the ENCODER ?

1 Answers  

---

How much Resistance Show by RTD(PT100) when it is installed in process(Consider Process Fluid temp 29 Deg C)?

5 Answers  

---

Area classification, Equipments, Gas groups, temperature classification, Ingress protection, Fire Extinguishers.

0 Answers   CCIE,

---

---

WHY WE NOT USE 2-20mA,1-20mA,3-20mA or 10-50mA SIGNAL? INSTEAD OF 4-20mA.

6 Answers   Hindustan Unilever Limited, Yashmun Engineers,

---

Why boiler chimney area  oxyden sensor fixing? 

0 Answers   NTPC,

---

I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.

0 Answers  

---

Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.

0 Answers   CCIE,

---

what is transducer?

13 Answers   Sofcon,

---

capillary type tranmitter using remote seals and capillary tubes filled with liquid of known of known density so if you wanna callibrate it just close block valve just before capilary @ high side & connect druck apply it's calibrated range pressure as normal calibration ensure low side block valve must be closed & if you asking commissioning so this is not a DP type pressure tx so simple if you wanna put in servie this tx just open high side block valve & than low side block same way i do it but still transmitter showing -13 ma.just tell me what i want to do ?

1 Answers   Gasco,

---

you are on site,the plant trips,you are approached by operations,what do you do?

0 Answers   ABB,

---