Answer / k.prakashchandra

More force with lower voltage and smaller coil than other types

i need to connect fact device(any one from following upsc,sssc,svc,statcom and tcsc)in 14 bus system....by using MATLAB psat software....if i connect these fact devices,i will get some error as "virtual error"...i cnt rectify this error.if anybody know that how to work in psat,pls help me to rectify this error.... or send mail me to, viki0607@yahoo.co.in

1 Answers  

---

we have two 11/.433 kv. distribution Transformer rating as 1000 kva & 500 kva , i wants to run parallel both transformer. both transformer impendence voltage is 5.24%, How can we run both t/f, & how sharing the load

3 Answers  

---

In case of any eventuality, who is your next of kin?

2 Answers   Edison, Foster Wheeler, GE, GE Energy, HP, Infosys, Koch Industries, Roper Industries, Siemens,

---

hi I have done 3 yrs diploma in electrical engg after 10+2. I have 16 years of work experience into design proposals sales and engg application development in LV/MV swithcgear and sub station automation field. I want to apply for immigration to new zealand but I am not sure whether I qualify or not since I dont have a degree. Can anyone advice? Thanks Riz

0 Answers  

---

What is the minimum value of hfe for the oscillations in transistorized rc phase shift oscillator?

0 Answers  

---

how to calculate the torque of a motor?

0 Answers  

---

How many percent of power are not being registered if we bypass one side of the meter base terminal using #8 cu wire on 1-phase kwhr meter. 

1 Answers  

---

how do we know the LT or HT panel trip by some broblem which indication willshow

2 Answers   TATA,

---

Why Ferranti effect not occurs at full load?

4 Answers   L&T,

---

an amazing situation was faced when an alive distribution panel with 415 volts and carrying almost 200Amps has become short and this metal cubical showing 220 volts against neutral and earth. to redress any confusion i checked the panel with help of single 200watts test lamp which also glowing with max.intensity b/w neutral & metal body of DB. amazing situation is that i hold the DB firmly more than once with necked foot means without insulated shoes but not received any electrical shock. whereas our all running gen sets neutral points also proper grounded and this short DB was completely earthed , this is beyond my understanding . any body explain how is it possible . our running gen set neutral also grounded firmly

1 Answers  

---

how to calculate IR value of 33KV cable ??

0 Answers  

---

why transformer rating in kva

6 Answers  

---