Can anybody tell which type of quections are asked in
interview for projects?
plz give its urgent.....!
Answers were Sorted based on User's Feedback
Answer / rajat jain
On projects following imp questions r asked:-
Most imp ques.-What is the application of your project?
Why this project?(Answer to this question must be pin
pointed as if u had chosen an offstream project.)
IS it cost effective?How much is the cost?
Is it practical i.e. can be implemented?
What is the working principle?
Draw and explain the block diagram?
description of power supply.
description of components if asked at circuit level.
Rating of each and every component
Cost of every component.
There a lot of questions on powersupply and coponent
structure.
For more ques contact me.
Is This Answer Correct ? | 3 Yes | 0 No |
Answer / vaibhav vt
In projects questions can be asked mainly on erection and
commissioing.
Also they can judge your overall project managment skills.
They can ask for any small example of anyproject you did.
they can mainly ask your role first in any project.
My advice--Do not lie and tell the truth only.Tell those
things which you are really good at.
Is This Answer Correct ? | 3 Yes | 0 No |
what is commissioning.
Types of contol loops
Why ues 250 ohms Resistor during hart type instruments calibration with hart protocol in details ?
Why we use DPT? can we use PT instead of DPT?
Why Ma signal is using for control system?
where proximity sensor installed on tank in loading arm application
selection criteria of control valve? and selection criteria of actuator explain in brief?
how far the two wire transmission (loop power) maximum distance suitable?
What is limitation of the ht.of the displacer of a level trol?
what is gas metering system? gas chromatograph? and gas compressors?
While giving Power Supply of 24 VDC to a Transmitter,why Shield Terminal is connected either at Transmitter or at ISB.Why not Shield Terminal connected at both ends.If the Reason is to avoid Noise interference,which type of noice that is interfering.Is the Noice from the 24 VDC supply terminals or from any external source.
I heard that we can use flow transmitter for level measurment also hw it is?