what is purpose of governor in desiel engine...
Answers were Sorted based on User's Feedback
Answer / mallayya
Purpose is to controll the flow of fuel to the engine
Is This Answer Correct ? | 24 Yes | 5 No |
Answer / rotimi
when fuel flow is controlled it indirectly controls the
speed of the engine.
Is This Answer Correct ? | 17 Yes | 4 No |
Answer / oluwaseun
The main purpose is control the speed of the engine
Is This Answer Correct ? | 10 Yes | 2 No |
Answer / gunasekar
Maintain the speed and regulate fuel according to the load
of the engine.
Is This Answer Correct ? | 5 Yes | 1 No |
To maintain the constant speed, irrespective of any load.
Is This Answer Correct ? | 3 Yes | 1 No |
Answer / york shipley
PALS
GOOD QUESTIONED?
FIRST WE SHOULD KNOW THE DIFFERENCE BETWEEN FUEL REGULATION
AND OVER SPEED.
THE ENGINE ACTUATOR OR FUEL CONTROL REGULATOR IS THE ONE
LOOKS AFTER
THE FUEL FLOW DEPENDING ON THE REQUIRED LOAD
CONDITIONS/FLUCTUATIONS AND PROVIDE FUEL ACCORDINGLY TO
MAINTAIN STEADY SPEED/ R P M.
THE "WATT' GOVERNOR IS A MECHANICAL PROTECTION DEVICE IN CASE
THE ENGINE IS SUBJECTED TO SUDDEN OVER SPEED/ABNORMAL R P M
THEN BY CENTRIFUGAL FORCE THE COUNTER WEIGHTS EXPAND WHILE
ROTATING AND HIT THE TRIP LEVER TO SHUT OFF IN COMING FUEL
THERE BY PROTECTING THE ENGINE FROM DISASTER.
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / aishwary mahajan
it maintains thevmean speed of an engine by the help of
supplying working fluid in it.
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / praveen kamble
governor is a device used to regulate d speed of d engine
i.e, to maintain constant speed of d engine irrespective of
load acting on d vehicle
Is This Answer Correct ? | 0 Yes | 0 No |
what is broadcast id for class a , class b , class c ?
What are the objectives of NVH (Noise Vibration and Harshness) analysis?
How can I weld A234 WPB and WPB P11 fitting? Any special heat treatment required? What happen if I weld both?
When mesuring the flow of liquid what are the two things to measure?
1.how to Ask the result After the interview gone? 2.please send me the interview questions of unigraphics,IDEAS,solidworks,autocadd,and mechanical design. to my mail id austinsobanam@gmail.com
0 Answers Ashok Leyland, Bhel,
What is the difference between isentropic process and throttlinglprocess ?
what is meant by parallax error
what is the difference between stress and presure althougth both have same unit.
Match the following A. Manas I. Hangul B. Dachigam II. Elephant C. Mudumalai III. Tiger D. Kaziranga IV. Rhinoceros
substance is flowing in a pipe of 200 mm inside cylinder diameter ot an average velocity of 3m/sec. At a given section of the pipe line the pressure is 1.5 MN/m² absolute. what is the flow work of 0.5 cubic meter, expressed in joules passing through section? (a)1J, (b)75000J, (c)90000J, (d)25000J
tell about a type when u had to use ur presentation skill to influence someone's.
every pump has a maximum H & Q. Also has BEP( Best Efficiency Point). But how can we fix a pump for BFP.