Which grade oil used in gear box.
Answers were Sorted based on User's Feedback
Answer / azruddin
Grade oil always depend on manufacturer recomemded and also
refer to same as abdul hameed say ans on viscocity, fire
point, flash point,but this question to general u must
describe what gear box, where use it, industrial or
automotive.
| Is This Answer Correct ? | 23 Yes | 1 No |
Answer / york shipley
gentle men
be informed from the expert
any gear box have gears of some
type(spur,helical,herringbone,worm bla bla bla\\\\\\\) and
for sure the gears have tooth/teeth hihhihihihihi
and by law the "mesh" and rotate.
agreed thanks,,,,,,
now meshing action means two surfaces kissing each other
||||||||friction boss friction got it
brother sure heat will generate and need to keep it under
certain value right,,,,, so for cooling and lubricating to
reduce wear and tear is the base line of purpose of use.
now no holy book saye e e e ey
o men use theeeee oill lllllll
it depends on
type of gear/ gears
ratio of transmission
type of construction of gear box design
temp need to sustain/ operate etc.,,
there are oil cooled gears boxes
there are grease cooled gear boxes
generally SAE 90 SAE 140 ARE IN WIDE USE
BUT STILL AS I SAID NO RULE OF THUMB
IT VARIES.
| Is This Answer Correct ? | 13 Yes | 2 No |
Answer / sunil
it depends on the gear box type and purpose usually
sae90,sae140 will do
| Is This Answer Correct ? | 8 Yes | 2 No |
Answer / jith
FOR INDUSTRIAL USE AMMOCAM 220/PARTHAN E 220 IS BETTER
| Is This Answer Correct ? | 5 Yes | 2 No |
Answer / jignesh
if it is the industrial gearbox then recommended grade of
oil is SP320.
| Is This Answer Correct ? | 8 Yes | 6 No |
Answer / ramanagu
Its depends on the gear box generally servo 460 was used
| Is This Answer Correct ? | 0 Yes | 0 No |
What parameters to be reported when we send lubricating oil for shore analysis?
water balance calculation for 1X500 tpd DRI plant?
Explain the difference between afbc, bfbc, pfbc and pcfb in regard to fluidised bed technologies.
What is coefficient of contraction?
what is continuous-emission monitoring(CEM)System?
what happen if petrol engine run by diesel engine?
Water is available at 10m height. What is the pressure available ?
what is steam temperature measuring unit in steam turbine?
What are the defects in exhaust valve?
HOW WE CALCULATE THE WELDING IN JOB.
Which outer cover is on the welding rod?
Small gear found in the steam turbine.
0 Answers ABC Inc, RRB, Siemens,
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)