how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.

0 Answers  

---

what is droop mode n frequency mode in wood ward governor?

1 Answers   TATA,

---

How to calibrate DP transmitter by using HART communicator ?

1 Answers  

---

What is the procedure of calibration of Load cell?

0 Answers  

---

i feel sq. pipe is better than round pipe pls give comment for this. advance thanks for reply

3 Answers  

---

---

Why we are using DPT(Differential Pressure Transmitter) in separator instead of level trasmitter?

0 Answers  

---

how to caluculate flow by using transmitter?tell me plz I am eagerly waiting for your reply..

2 Answers   Agi Glaspac, Reliance Power,

---

Why we not use 2-20Ma or 1-20Ma

5 Answers  

---

What is defferent betwen ESP &PCP PUMP .HOW IT IS WORK?

0 Answers   Jindal,

---

Dear All can any one told me that VFD Make ABB Model ACS800-01 used for dual Source like 1.DC Source applied at terminal UDC+,UDC- 2. 3 phase 400AC,50Hz

1 Answers  

---

TCD Principle

1 Answers  

---

Gas equation

0 Answers   CCIE,

---