Answer / 9033485167

it is works without thermowell

Answer / abhilash

It used to measure the surface temperature of a body...that means in heat exchangers we need to know the temperature in surface ....it welded to the surface......

Answer / ejazmaqsood

Skin type thermo couple is used to measure the temperature of the body.It is injected to the surface of the body to which temperature is measured through a Insulating pad,so that it collects temperature.

Installation not put directly inside the pipe. only outside the the pipe.

Why we use the double acting control valve in flow line?

3 Answers  

---

How a oxygen sensor & analyzer work at boiler or furnace, whats the principle & science is beyond this,How O2 sensor sence & convert signal & move toward analyzer & analyzer show reading in percent?

2 Answers  

---

Why upper weighing limit of electronics balance is 90% of the total weighing capacity?

0 Answers   Emcure,

---

how can check the loopchecking for valves?

3 Answers  

---

i have been asked by QAFCO to appear for interview for thy post of Instrument Designer(INTOOLS)..i m engineering graduate with 5 years exp. in design engineering.Will this job profile suit me??i need all ur help n suggestions for thy same?

0 Answers   QAFCO,

---

In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?

0 Answers  

---

What are different types of orifice plates? State their uses.

0 Answers  

---

what is the difference between cold loop and hot loop

2 Answers  

---

how to connect the HART protocal with control valves

1 Answers  

---

How to calibrate the control valve.

1 Answers  

---

Is that Speed Probe and Vibration Probe sensors are same,if yes what is the diff b/w them?

2 Answers  

---

if a tank is contaning oil and water than how can we measure the oil and water level seperately

3 Answers  

---