How many hope count rip or rip2 can send updates?

0 Answers  

---

What command do we give if router IOS is stuck?

0 Answers  

---

Identify the command to determine if an IP access-list is grouped on interface e0? A.) Router(config)# show ip interface e0 B.) Router> show ip interface e0 C.) Router# show interface e0 D.) Router# show ip interface e0

1 Answers  

---

Identify the command to configure the IP address 172.16.100.5 255.255.255.0? A.) Router(config-if)# ip address 172.16.100.5 255.255.255.0 B.) Router(config)# ip address 172.16.100.5 C.) Router# ip address 172.16.100.5 255.255.255.0 D.) Router(config)# ip address 172.16.100.5 255.255.255.0

2 Answers  

---

What do the following commands accomplish? access-list 1 deny 172.16.4.0 0.0.0.255 access-list 1 permit any interface ethernet 0 IP access-group 1 out A. This will block traffic from subnet 172.16.4.0 and allow all other traffic. B. This will allow traffic from subnet 172.16.4.0 and block all other traffic. C. All traffic is allowed. D. All traffic is blocked.

1 Answers  

---

Suppose we are having two Switches i.e. Switch1 & Switch2 Port1 of Switch1 is Connected to Uplink and switch2 is also connected to switch1? So 1>Is there is any loop? 2>How we come to know that there is a loop created? 3>If we add Switch3 to switch2 then there is a possibility of loop Creation?

0 Answers  

---

as we know that isdn bri port come with either a u interface or some thing s/t interface what is the diffrenmce between them

2 Answers   HCL,

---

What is mtu and what is its size for transmission?

0 Answers  

---

Identify 2 reasons for disabling CDP? A.) If the router is not configured for RIP B.) Save bandwidth by eliminating overhead C.) If the router is configured for Appletalk D.) When connected to a non-Cisco router

1 Answers  

---

Which type of routing you did in ccna?

0 Answers  

---

What is the difference between switch and hub?

0 Answers  

---

In which access- list type you can't do editing?

0 Answers  

---