Pressure tx shows 1 mbar but we need 1000 mbar at this process condition .. how can we sort it out .
No Answer is Posted For this Question
Be the First to Post Answer
If i want use the 6 kg/cm2 pressure gauge then how to calculate its pressure gauge range?
the square root type transmitter r used to which applications
Why grounding is necessary? Give example with diagram.
0 Answers Bright Point, DS Group,
If an Instrument has 550 ohm internal resistance and the cable used for that instrument is 0.5 ohm per meter resistance. If the voltage is 12volt.How much length cable can be used? Please tell me its Calculation formula.
Is Hart communicator calibration device or communicating device for transmitter?
what is the safety integrity levels (SIL)
what is the procedure to isolate flow a transmitter and flushing it?
In RTU Panel we are having several Analogue & Digital Inputs /Outputs. We are recently facing some problems over Analog inputs , which are not updating properly (But Digital Input are updating normally) Can any one tell me from where the problem is creating , we have checked PLC CPU card, Analog Input card & we reconfigured ,But still the issue is there. Issue : 1. Sometimes Analog values are updating & sometimes not. 2. Analog values are not updating normally , showing some wrong Values 3. Total dead (0 value) Analog values are Level & flow measurement from the field instruments. (But in field the instruments are working normally & Displaying the values normally in local display unit) This problem we are facing in our Water Plant. If any one experienced this same problem or having any ideas related to our issue PLS send your valuable Answers/Replies...
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
how to relay switch sense the fault?
Transducer Input 0 to 230 v ac Output-0 to 10vdc Receiver Input 0 to 10 vdc and Output 4 to 20 ma How?
GIVE BRIEF DESCRIPTION ABOUT "DCS"