What is Hysteresis mean in Instrument?

11 Answers  

---

What is cascade control in process instrumentation?

4 Answers   Engineers India, ITC Infotech,

---

I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?

0 Answers  

---

there are two candidates p and q in an election.During the campaign,40% of the voters promised to vote for P ,and rest for Q.however, on the day of election 15% of the voter went back on their promise to vote for P and instead voted for Q. 25% of the voters went back on their promise to vote for Q and instead voted for P.suppose,P lost by two votes,then what was the total no. of voters.

1 Answers   GATE,

---

How d.p. Transmitter can be applied to close tank?

0 Answers  

---

we have a s-5 simense plc having op7 .recently on op7 showing error 1.plc not present 2. DB error frequently. can u have any solution . please send me.

0 Answers  

---

how manys ways dp transmitter can be calibrated having range of -150 to 400mmwc,what side pressure u will apply?

3 Answers  

---

What is the purpose of LO overhead tank in turbines.

1 Answers   ADMA OPCO,

---

Which of the following instruments consumes maximum power during measurement?

3 Answers  

---

We do have a problem in the company that is one PT connected to PlC which is mean 1 out of 1 in PLC system we do have the PAHH is 55 mbar and PALL 8 mbar with a timer of 15 sec for the PAHH the problem started when PAHH goes more than the set point which is 55 it reached up to 71 but due to timer doesn't trip . We force it and we checked everything nothing there . We replaced the transmitter problem still there the reading goes more than the 55 bar the range for transmitte is 0- 60 mbar . So we did loop check , aculaizing valve , wiring all are okay . What the possible causes for this ???

2 Answers   National Petrochemical Company,

---

Explain the usage of the PLC system?

3 Answers  

---

what is the diffirence between Earth and Neutral

4 Answers  

---