What do you do as a Engineering person EPC for
Sizing&Selecting Control Valve?
Prepare AVL (Approved vendor list)
You need provide basic design data which includes but not limited to Temp., Pressure, Min., Max and no0rmal operating flow. Other requirement viz., Hand-wheel requirement, Max. opening time, limit switches SOV, available air pressure @ site, Noise requirement (< 85 dB) leakage class, You need spring return actuator or double acting ? what is the service (corrosive, Slurry, Liquid, Gas ) positioner requirement , booster etc. etc. and primary calculated CV.
Perform offer / bid evaluation.
Vendor meeting if required.
Provide inspection schedule , Delivery schedule. Preform factory inspection and sometimes site installation (based on company requirement) and inspection.
Is This Answer Correct ? | 1 Yes | 0 No |
During the design and engineering of a process plant, a good designer should plan for ____________, ___________ and ____________ aspects of the plant
Valve positioner and actuators in detail.
what are the programming languages used in dcs
I HAVE PRESSURE TRANSMITTER WITH TWO WIRES 24 VOLTS SUPPLY.IF TRANSMITTER WILL GIVE SIGNAL TO THE DCS WHAT HAPPEN TO THE 24 VOLTS POWER SUPPLY IT WILL DROP OR REMAIN TO 24 VOLTS POWER SUPPLY.
give eg of how I/P is used in control loops
sir, i preparing hpcl,ongc,barc,hal exams(instrumentation engg)pls send a placement papers
Draw a 3 element level control loop and explain
what is skin thermocouple?
Why shield is not connected at both end.
thermocouple output is AC OR DC??
I am using 971 Enraf radar level transmitter for LPG tanks ,the tank side indicator gives the error code 999999999FL can any body give me any diagnostic for this issue?
What is offset in a control system.