Answer / vdw

If a system needs high starting torque then corresponding motor will draw very high current, in such a case it may get overload or probably causes electrical flash which is not acceptable. The remedy for this is to use star delta starter for the motor so initial current drawn by motor will be within safe conditions of motor.

Answer / anusha.choppara

decrese the life time of the system

what's interlock relay ?

3 Answers   International Mega Food Park Limited, National Power Training Institute NPTI,

---

what is turn down ratio

4 Answers  

---

What is MFT and when it is acted.

2 Answers   HPCL,

---

what is the formula for converting mmwc to tph in a dp type transmitter.what is the range in plc(in tph) if dp tx.range from 0 to 5000mmwc.

2 Answers   CCC, Korba Power Plant, Shyam Steel, Utkal Alumina International,

---

How to control cooling tower alge

1 Answers   GPL, SPY Agro Industries,

---

63.5 ohm NGR is connected with our gas engine genrator running at 500 rpm, 50 hz and synched with WAPDA at 6.3 KV bus voltages, 2500A and 25KA(1 sec). can some one give me proper calculations how it comes 63.5ohm?????

2 Answers   UET,

---

what does mean by kva rating

0 Answers  

---

what equipment is most efficient in power plant?

4 Answers   Adani,

---

Why high pressure turbines are single flow 

3 Answers  

---

I am opertaing generators which are beyond 14000hrs and now the fuel consumption is about 2kw per liter of diesel. The engines are due for overhauling. is this normal

1 Answers  

---

Difference between electrical and electronics?

7 Answers   Power Plant,

---

why IBD Vent is kept at higher elevation than CBD ?

5 Answers  

---