what happen if one of 3-phase line has a much higher load when we are using de

what happen if one of 3-phase line has a much higher load when
we are using delta to star transformer?
how we can over-come from that?

Question Posted / akash ray

2 Answers
6108 Views
Getco, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

what happen if one of 3-phase line has a much higher load when we are using delta to star transfor..

Answer / sb

Upto certain extent it is allowable but beyond that O/C
relay may trip the circuit.
As said by the above friend abnormal neutral current will
flow & hence through the CT sec side & will actuate the relay.

Is This Answer Correct ?

6 Yes

1 No

what happen if one of 3-phase line has a much higher load when we are using delta to star transfor..

Answer / jigar bhanushali

Due to it system will be unbalance hence there will be some
neutral current .now if neutral of sta load is not grounded
then there will be harmonics ingection in the line which
will give poor performance of equipment used at load ide.

Is This Answer Correct ?

8 Yes

4 No

Post New Answer

More Electrical Engineering Interview Questions

whats the necessary to correct the power factor using capacitive banks in industries?

2 Answers

IAM WORKING IN THERMAL POWER PLANT AS A TRAINEE.. I WANT TO IMPROVE MY CARRIER., IF ANYBODY KNOWS ANY COURSES., ANY TESTS, ANY BOOKS ,, ANYTHING PLS HELP ME..

2 Answers

what is the principle of tubelight ??? what is the function of starter and choke ???

1 Answers

what is priming pump?why it is used ?

2 Answers

my question is that....few days ago i had installed a three phase motor starter for an electric saw.the motor will run and make the hydraulic pressure which will be goes to pressure cylender by up and down lever.two number of limitswitches are also installed on cylinder for safety of motor.now when the arm of cylinder reaches to the upper or lower limit it will cut the motor's line.and motor will be stop.now wana know that what will i do that motor runs continue after the limitswitch cut it down but it shold not be made any pressure.pls answer me in brief.

3 Answers

Why indicated only R.Y.B to phase.

6 Answers Bhel,

how to syncronize two dg sets

3 Answers

WHY CURRENT DECREASES WHEN VOLTAGE IS INCREASED IN A CURRENT TRANSFORMER ?

5 Answers Sterling Wilson,

A 25MVA 3300/400V T/F is termed as per winding is …… a) primary 3300V & Secondary 400V b) primary 3300V & low voltage winding 400V c) High voltage winding 3300V & Secondary 400V d) High voltage winding 3300V & low voltage winding 400V

4 Answers Engineers India Limited,

what will happen if we give a dc supply to a transformer.?

10 Answers

i want to know about psu exam eligibility critaria?

1 Answers ISRO, PSU,

What type of DC motor would you see for a lift?

0 Answers Ericsson,

For more Electrical Engineering Interview Questions Click Here