Answer / pankaj deshmukh

As mentioned open circuit test there would be zero current , and when frequency is doubled it also does not cause any change in current and P.F.
there may cause a little more eddy current in winding, This may cause any trouble in transformer though this test is being done for check winding insulation bearing capacity.
if this answ. is found any mistake or wrong concept kindly text msg in your ans.

what is the meaning of harmonic in AC waves and when which are prduce and what is the effects on line and give any other information about harmonics

1 Answers  

---

why in some cases the receiving end voltage is higher than the sending end voltage in transmission line (called 'Ferranti effect') ????? whts the reason behind tht???

3 Answers  

---

what is the difference between synchronous generator & asynchronous generator

4 Answers   Reliance,

---

Why an ac systems are preferred over dc systems?

0 Answers  

---

15 kva dg set single phase takes 63amp( approximate) while same rating 15kva three phase takes 35amp approximate. why ? and what will be per phase current for 15 kva

2 Answers   TVI,

---

---

How do I calculate/select Droop CT ratio for various capacity of generators?

0 Answers  

---

Hello Can I use step up HV transformer 440/4160V as a step down? Thanks Evgeny

5 Answers  

---

What is mechanical interlock?Explain the uses?

2 Answers   HSL,

---

How does the phase sequence controller works, how it identifies the phases? confirm working principle

0 Answers  

---

in an electronic tri vector meter when the current and voltage sequence changes ? what is the effect of phase sequence on recording of meter

0 Answers   L&T,

---

block diagram of 2 ups system connected in hot stand by mode?

0 Answers  

---

what is the difference between MCB and MCCB?

4 Answers  

---