What is the fullform of IPS in substaion using Aluminium
Tubes
Answers were Sorted based on User's Feedback
Answer / k.prakashchandra
I think it is 'Iron Pipe Size ' which is an old pipe sizing
system still in use as a standard .
| Is This Answer Correct ? | 35 Yes | 28 No |
Answer / sakti prasad das,optcl
I think it is "International Pipe standard"(IPS).But some
Industries say as "Iron Pipe size" which is an old pipe
sizing system still in use as a standard .
| Is This Answer Correct ? | 6 Yes | 5 No |
Answer / gopalakrishnan.s
THIS IS A TUBE TO AVOID THE SHARP EDGES IN BUS BAR DUE TO
THAT SKIN EFFECT WAS MINIMIZED
| Is This Answer Correct ? | 6 Yes | 7 No |
what is deffrent alternatid and gernater
Why are use 22 kv 3ph supply ?
Why only three phase power generation are load are used
Inverter. converter. Ups.MCB.solar.alternators. motors.
What will happen to magnitude of voltage of other two phases if one phasw will touch the ground?
3 Answers Construction, NPCIL,
what is reactive power?, why its measured in VA ? is it transient behavior of system?
What is method of calculating the fault current for a MDB, 50KW, 3PH, 415V, 50HZ?
why frequency should be constant?
'documenˁ
A cylindrical wire is compressed in length by 10%. The percentage decrease in the resistance will be?????
Define availability (operational)?
what is IP65 & What is its advantages
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)