Answer / any

indication of umber light is error signal ,shut down server
remove hard disk and clean it and again mount it and
restart the server.
if umber light still present then you have to replace faulty
disk and server automatically rebuilt the data

Answer / anbu

no

how i can Design a client–server network with two servers operating at 100Base- T Fast Ethernet speed and the clients operating at regular 10Base-T Ethernet speed using a 10/100 Mbps NIC. The hub is located in a wiring closet, but the servers and clients are not. Assume that a satisfactory performance is achieved at 40% utilization of the LAN.

0 Answers   Kent, Kent State University,

---

Can Area no 0 and area no 1 communicate by default in ospf router without ASBR or ABR routing protocol

8 Answers   Aricent, HCL, IBM,

---

You have a class C subnet. You would like divide it up into 5 more subnets by "subnetting". However you also have to have at least 31 hosts per subnet. Can you do it ? a. Yes b. No

1 Answers  

---

What IP network addresses are set aside for class C (for private use) ? a. 172.16.0.0 (mask 255.240.0.0) b. 172.16.0.0 (mask 255.255.0.0) c. 196.168.0.0 (mask 255.255.0.0) d. 192.168.0.0 (mask 255.255.0.0) e. 198.168.0.0 (mask 255.255.255.0)

1 Answers  

---

Which command will show the device/system being used for the printer fred ?

1 Answers  

---

---

What is 10base-t?

0 Answers  

---

Which OSI layer provides synchronization by placing checkpoints in the data stream.

1 Answers  

---

what is networking?

8 Answers   TCS, Wipro,

---

Can ATM allocate bandwidth on demand ? a. Yes b. NO c. Only if you are running LANE d. Only if you are running layer 3 switches

1 Answers  

---

All IP addresses are eventually resolved to network interface card addresses. Which of the following is used to map an IP address to a network interface card address? a. WINS b. DHCP c. DNS d. ARP

1 Answers  

---

You have a class C subnet. You would like to divide it up into 10 more Subnets by "subnetting" . How many hosts can you have per subnet?

1 Answers  

---

Default subnet mask for Class A, B, and C ? a. 0.255.255.255, 0.0.255.255, 0.0.0.255 b. 255.0.0.0 , 255.255.0.0, 255.255.255.0 c. 255.255.255.0, 255.255.0.0, 255.0.0.0 d. 0.0.0.0, 0.0.0.255, 0.0.255.255

1 Answers  

---