Answer / rituraj

Restart inhibit is a protection in ht motors against frequent starting.Heat is generated in motor during starting so motor starts per hour is limited to ht motor in order to avoid heat generation inside windings so a motor cannot be start before a time limit after a stop.

Why electricity is generated and transmitted at the values of multiples of 11?

3 Answers  

---

Can 33kva/415v transformer be run underground? If the answer is yes why and if the answer is no why?

0 Answers   4T Technologies,

---

How to calculate load taken by a cable?

3 Answers  

---

Whats meant by trivector meter where it is connected at the substation?

20 Answers   GPIL, Infosys, Jakson, L&T, Secure Meters,

---

what should be correct gas pressures to be a 1.5 ac unite

0 Answers   DDK,

---

when will be the iocl interview results ifaced the interview on september 8 th

0 Answers   IOCL,

---

What happens when generator is running with leading power factor on it say -0.96. what are the effects of it on alternator and the other generators operating in parallel to it.

2 Answers  

---

sir i completed apprentice in TNEB.apprentice is eligible for 'c' licence

0 Answers   Bhel, TNEB Tamil Nadu Electricity Board,

---

when a cunductor is being disconnected from live cct, still it showing charged, if its checked by line tester?

8 Answers   GEB,

---

Which of the following alternatives will be cheaper (1) A 100 h.p AC, 3-phase motor (2) Four motors of 25 h.p each (3) Five motors of 20 h.p each (4) 10 motors of 10 h.p each explain

0 Answers  

---

what is a difference berween line voltage and phase voltage?

2 Answers  

---

We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.

0 Answers  

---