Interested to Buy Any Domain ? << Click Here >> for more details...
Identify the command to run 'setup'?
A.) Router(config)#setup
B.) Router?setup
C.) Router#setup
D.) Router>setup
- 1 Answers
- 5468 Views
- Karrox, I also Faced
- E-Mail Answers
If i had 400 computers set in a site how many VLAN i should configure so that i can share a proper bandwith,and also i had two lease line connection of 2Mbps each,
Which type of routing you did in ccna?
What is the easiest way to remotely configure a router?
which device/card is used at the end of computer/device to connect multiple or different wire of mesh topology to a single computer/device?
1 Answers Adepto, British College, Wipro,
Which of the following is true? A. The default is to send debug output to the console screen. B. To view debug output from a telnet session, the "terminal monitor" command must be used C. If the "logging buffered" command is used, the debug output would be sent to RAM and can be viewed with the "show log" command D. If the "no console loggin" command were configured, output would besent to a telnet session E. All of the above F. None of the above G. A, B, and C. H. A, C, D, and E.
Hi, Can any one please tell me the experience of their CCNA interview,and please tell me all the questions they asked in the interview. Many Thanks...
What does the 'S' mean when looking at the routing table? A.) Statically connected B.) Directly connected C.) Dynamically attached D.) Shutdown route
Differentiate full-duplex from half-duplex.
What are the two most common transport layer protocols? UDP TCP IPX ARP
What is the draw back of eigrp protocol?
What does the command show access-lists 101 list? A. all defended access lists B. all access lists within the router C. the contents of standard access list 101 D. the contents of defended access list 101
Differentiate User Mode from Privileged Mode?
CCNA 
