What is the formula for Tapdensity /
Answers were Sorted based on User's Feedback
Answer / ramus
Tap density=Weight of the sample/Volume of the silinder
after tapping the sample
Is This Answer Correct ? | 27 Yes | 3 No |
Answer / reshma ghadge
density means mass/volume
tapped density = Wt. of sample taken / volume of sample in
the cylinder after tapping
Is This Answer Correct ? | 17 Yes | 0 No |
Answer / murari
Tapped Density- W/V
where W is weight of sample
V is final tapped volume
this is as per USP
Is This Answer Correct ? | 10 Yes | 1 No |
Weight of the substance
Tapped density = --------------------------
Volume of the substance (after tapping)
The density of solids normally expressed in g per cm3
and liquids is normally expressed in g per ml. However
because powder volumes are measured in cylinders graduated
in ml, tapped density is expressed in g/ml.
Is This Answer Correct ? | 5 Yes | 0 No |
What is the use of tailing factor ?
What is third generation HPLC Columns?
Why potassium hydrogen pthalate is used for perchloric acid And naoh. Why it is used for both acid and base
6 Answers Vijayasri Chemicals,
how to Calibrate FID IN GC
How can we confirm the HPLC column is end-capped or not? Is it possible to identify by physical appearance?
why PH range 0-14 explain
5 Answers DRL, Reddy Labs, Saint Gobain, Viva,
What is the principle of Thermal conductivity detector and FID?
[3/28, 20:52] Manoj P Venkatpurwar: how many impurities require to inject in assay specificity that how we can find out? and in Rs also how?
In the test for control of absorbance in UV calibration why do we use only potassium dichromate and what is purpose of taking a specified amount of 57.0-63.0mg?
what is difference between assay&purity&potency?
WHY POTASSIUM DICROMATE USING IN UV CALIBRATION
1 Answers Apotex, Micro Labs, Rene,
What is the size of capillary tube used for analysing melting point?