what are the basic instructions used in simatic s7-300 plc?
Answers were Sorted based on User's Feedback
Answer / pankaj kumar
jump instruction
bit logic instruction
shift and rotate instruction
load and transfer instruction
word logic instruction
Is This Answer Correct ? | 3 Yes | 0 No |
Answer / linilbabu.ck
Researcher & Developer
Please send more info regarding the simatic s700-300plc?
& developed Smallest CNC machines In single IC 89c51
My mail ID:lb.industries@yahoo.com
L.B.Industries
Perambra
calicut
Mob:9846956049
Is This Answer Correct ? | 1 Yes | 1 No |
Answer / wayni
Please send more info regarding the simatic s700-300plc?
My mail ID:wayni@iway.na
Is This Answer Correct ? | 0 Yes | 1 No |
Answer / mohi
sir, plz send me too the information, my mail ID: link2mohi@gmail.com
Is This Answer Correct ? | 0 Yes | 2 No |
Answer / moath
send me your mail i will send you some thing veru useful
regarding S7 programing
Is This Answer Correct ? | 4 Yes | 7 No |
can install leveltrol in steam drum for measurment the level of steam drum? if not then why?
why r using 250 resistances
how to calculate flow range in DP tx
My flow transmitter range is 0-1000mmwc.DCS range is 0- 100m3/hr.What is correspond out put in terms of milliamps if my flow is 65m3/hr
A pressure transmitter with a range of 0-100 bar.The accuracy of the instrument is 1% of upper range value? The pressure indicating transmitter is showing the system pressure is 50 bar. b. When you include the error, what is the minimum possible pressure in our fuel gas system? i. 49.5 bar ii. 49 bar iii. 1 bar iv. 0.5 bar We want to change the filter cartridge. We must depressure the fuel gas system. c. After we depressure the system in preparation for maintenance, the transmitter displays a pressure of +0.1 bar. At this time, what is the possible range of pressures in our fuel system? i. +0.099 to +0.101 bar ii. 0 to +0.2 bar iii. -0.1 to +0.3 bar iv. -0.9 to +1.1 bar
In bimetallic temp. Gauges why does metal strip bend? Why do we use low expansion factor metal and high expansion factor metal in bimetaliv strip?
1 Answers Process Control Technologies,
Differentiate between ultrasonic flowmeter and radar type flow meter
i want to control the temp of sand(welding flux) between the range of 150deg C to 170deg C. sugges me sum temp control method without PID controller.
Explain the difference between mmwc and mmwg?
how to calibrate differential pressure switch
why are use only 4 to 20ma. signal.
why we are using ungrounded RTD sensor and what is difference between grounded RTD and Ungrounded?