Answer / ganesh

You have to go with positive mind
Don't think that this is the end of the world if u didn't present well.
Don't compare with anyone we all are unique
"We all are different,however if bad life may seem there is always something u can do and succeed at. where there is life there is hope"-Stephen hawking

how much cubic feet cement contain in one bag

12 Answers  

---

States some of the commonly used commands in cad software’s?

0 Answers  

---

What is cementation

1 Answers  

---

In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.

0 Answers  

---

what is the specification for silt content in sand

8 Answers  

---

i have open space in my house, i want to make pcc there, si want to know how i calculate material , my area measurement is 10' x 10' x .25', pls tell me how much need cement, sand, concrete,if possible u than pls tell me the formula

1 Answers  

---

what is the ratio of M10,M20,M30,M40,M50,M60 grade concrete

28 Answers   NCC, PWD, SPML, Student,

---

Please Clear My doubt . We Can Design the size of the beam by manually by the Length of the beam...What is the technique adopted

0 Answers  

---

what is the procedure involved in preparing mix design of m15 grade as per IS-10262-1982

0 Answers  

---

How to calculate labor requirement or requirement of labor projction for a proposed multistoried building for which quantities of different items of work has been already calculated stage wise ?

3 Answers  

---

how to decide the mortar ratio 1:4,1:6 in masonry? same in plaster 1:3 and 1:4? which code or any document reference taken to define proportion?

0 Answers  

---

what's the formula for calculate pcc for matt(45mm aggregate)?

0 Answers   L&T,

---