Determine the manipulated variable, controlled variable,
and the measured variable given a description of various
typical industrial processes.
- 6 Answers
- 39848 Views
- Honeywell, I also Faced
- E-Mail Answers
Answer Posted / sreenivasan
let e---error,r--setpoint(reference),b--feedback(measured
variable), m---manipulated variable, c---controlled variable
Now
1)e=r-b
2)c=(Control action*e) + Bias
3)m= c(after final control action)
| Is This Answer Correct ? | 13 Yes | 13 No |
Post New Answer View All Answers
1)How many tpes of vibration probe and how many tpyes of vibration. 2)how we can calibrate a vibration probe with tk3 3)what is RMS value in vibration measuring application and how we calculate it.
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......
describe flow nozzel principle?
why is an oxygen sensor used in a boiler stack
May I have a brief note above the voltage barriers? Whats is the purpose? Please mail me if you've operational details, mail id: rajkumar.diice@gmail.com
steps for installing orifice plate?
What are the interlocks we have to check during the start up of LP/HP compressor?
defination of radial vibration?
where proximity sensor installed on tank in loading arm application
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
What are different types of control valves?
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
i have done DAE in Instrumentation and Process Control. i have applied for an apprentice training in chemical company after three day my interview will be conduct but i need more information about industrial process control and controller. my e mail is imran_dilsetu@yahoo.com please tell me interview question relative to instrumentation ?
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
