You just entered the following command_Router(config#) line
console 0 Which operation is most likely to follow?
A. Confound terminal type
B. enter protocol parameters for a serial line
C. create a password on the console terminal line
D. establish a terminal type 4 connection to a remote host
E. change from configuration mode to console privileged mode
- 10 Answers
- 14838 Views
- Intel, Quark, Wipro, I also Faced
- E-Mail Answers
Answer Posted / bharghava srinivas
Ans: C
Reason :As in the Question it is mentioned as "LINE CONSOLE
0" it means it has entered into console mode,so we will
create password for the console terminal line....
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
How many types of router?
Can you describe the Authentication Header (AH) Protocol?
What are the steps of conversion for data encapsulation?
How many fillers we can put in one ip of ipv6?
Name the command we give if router ios stucked?
What is cam?
Explain the difference between baseband and broadband transmission in ccna?
Can you explain in a generic manner the packet of IPSec?
How do you configure a cisco router for routing ipx?
Can you explain static and dynamic tunnels?
What is the usage of service password encryption?
In stead of 0.0.0.0 wild card mask what you can write after ip?
Tell me how much hold down time of eigrep protocol?
What route entry will be assigned to dead or invalid route in case of RIP?
what is prefix list
