Answer Posted / emmanuel
This is a ratio of penetration of a standard plunger at a standard rate in a soil sample placed in a standard CBR mould to the penetration of the same plunger in a standard material.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Cement consumption of one cubic meter of aerocon blocks masonry?
one steel fixers how much ton steel fabrication he will do same how much tone he will binding?
How much cement and water required for cement selery????
What is semirigid connections?
What is dead load impact load live load
what is hydrostatic paradox?
The foundations are placed below ground level, to increase?
i want to ecil (Electronics Corporation of India Limited Hyderabad) previous civil engineering question papers immediately please.............
Reinforced concrete: suppose you are doing rough estimate for purchase of rebar for reinforced concrete slab for single stores residential building. You know total concrete volume will be 100 m3. How many tons rebar 6, 10 and 12mm will you require for the project?
What is Critical path in Ms-Project ?
how to calibrate the RM 800
is there any codal provision for soil cousion over the Hume pipe of Dia 1.2 m.
what is the use of steel rods of 16mm or 20mm used for 4.45mts for closing gutter.one mate consumes how many kgs with a gap of 6inches.
What is an object snap mode?
What is proportion of PCC Grade G?