What are all the type of vibration measurement measuring in
turbine, what is the output of vibration sensor.

Answer Posted / abu maryam

Vibration measuring philosophy may depend on position or speed measurement.
may be measured by sensor use npn transistor and eddy current produced from movable part affect it.
Some sensor is as bellows when the movable part touch it it give signal.

Is This Answer Correct ?    0 Yes 0 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?

1421


ORP sensor working principle?

1537


what is the procedure for auto tune in masoneialn 12300 series displacer type transmitter?

1228


How to calibrate an pressure gauge with yantrika test bench?

2383


NSV type probe stands for

1985






OBJECTIVE TYPE QUESTIONS OF ANALYTICAL INSTRUMENTATION

10305


What is the reason PT speed not incresed in gas turbine?

1926


Describe a time when you anticipated potential problems and developed preventive measures.

2491


What is the use of control cable?

696


Explain plc level and its type?

763


why we are not using the turbine flow meter in the steam service?

1721


We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.

1148


What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?

641


what is actual drum level and compensated drum level?

1775


how to convert MA in to measuring values..and how mwasuring values into MA ?..plz ansr.i have intervw

2141