Two bulbs of 500w and 200w rated at 250 v will have resistance ratio as ?

Answer Posted / shyam kuma

P=V^2/R
V=Constant
So ratio will be 2:5

Is This Answer Correct ?    79 Yes 10 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

How can we connect additional batteries to three phase ups? What are parameters we have to check when connecting?

1512


is there any lightning by passer is arranged in ship like buildings?

1480


A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .

2148


How to calculate mf when meter equipment and meter are connected

1277


Explain what is use of lockout relay in ht voltage?

681






i want to apper for apgenco or aptransco or related can any one sugest me where can i get previous papers of thouse exams

2829


mccb service sittings be done?

1370


if sf6 gas low in gis what will happen

385


what happen if field of dc shunt motor opens? what is function of putting res. in parallel to one phase of 3 phase IM? the power supplied by 5A source in circuit is given by------Watt.

1556


Discuss about gear cutting machines.

795


what is the star delta connetion and how can do it a three phase motor with control witing with picture

1814


Does all the output contacts (N/O as well as N/C) of a Numerical relay operate when relay receives a binary input/inputs or contacts are designated to specific logic input/inputs and only these contacts operate?

1619


How to back charge the Gas turbine generator

1622


Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault

1707


What is the formula for selecting the cabels according to load? How to calculate what sq.mm cabel to be used?

993