What is purpose of APFC panel?
Answer Posted / dhamsa prashanth
apfc fulform automatic power factor correction.it is used to improve the power factor then the lossess wil be less and also reduce the electricity cost.in the system have one relay used these the advaantages above these ans
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is the difference between rulling span and wind span of of an Over Head Transmission Line?
For high frequency application we use which transformer?
What is steady state response?
1)How much current can a 3-1/2 core 100 mm wire carry? 2)What are the special cables required for explosion proof wiring? 3)In case you do not have coal and salt for earthing, how can you achieve good temporary earthing? 4)One horse power single phase motor is more likely to get hot than a one horse power 3 phase motor. Is it true or false, if true why? 5)What are the different types of soft starters for large motors?please explain?
what is the meaning of number in (11, 31, 61,14, etc. CDG11, CDG31, CDG61, DDT32
How many types of interlocking use in screw type air compressor,make-Kaser(BSD MODEL)?
what are the possible reaons & remedies if resistance of NGR getting heat up
What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?
If we impress a dc voltage of 230 V on an unloaded 230 V, 50 Hz transformer it wi A give high secondary voltage B burn out C give secondary voltage as per K D none of these
how do we calculate length of starting time and repeated starting of a direct online starter?
why in an industry; machine having rated 200 h.p stopped after power factor is maintained above 0.97 lag by control panel in view-of energy saving
What is the typical enclosure type used for Indoor switchgear / Outdoor switchgear Units? - In Onshore / offshore Units?
If oil and air can withstand a high MeV when used as an insulator in a transformer, what are the values of how high for each material?
How we can come to know the substation range,without go through any name plate ?
What is meant by impedance? difference between high & low impedance ?