how to reduce the co level in your 1000kva dg set side?
Answer Posted / satya dev
There are so many factors to emmiring the CO of generator set eg. poor filterarion of fuel,rocker leaver arm are not adjuested properly that is why fuel not consuming properly. fuel quality may not be good.
So you need to set all the parameters and operate the genetaror atleast 80% load to reduce the CO level.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
does the Trivector Meter of three phase automatically takes care of the low power factor and gives the reading accordigly or it does not take care of the Power factor while giving the readings please explain
What is the different between conventional MCC and intelligent MCC? Common controller or controller for each bucket
what are the things that can cause a three phase motor to crawl?
Is there a standard depth of gravel fill in Substation Switchyard? Please give a design/drawing. Thank you.
What does the term supermesh means?
DIFFERENCE BETWEEN NORMAL TRAFO AND THRISTER TRAFO?
Pl. share your experience about industrial-electronics repair of machine tool.
Explain (in simple ) - root mean square. whats its role in electrical fundamandal.where its used
In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
what is POTT and PUTT explain?
Did RMU have ct and pt ?
Actually I have a doubt on neutral and earth.we use Ac power without taking neutral by connecting to earth,but at that time does it affects on efficiency of any electrical components or no? If yes how?
For group 1 , 2 whather i have to prepare my technical or general studies etc? and im graduate in ee engg. for wht posts im eligible for? please tell me!
explain why core loss of a transformer is almost constant under different load conditions when connected across a constant voltage and constant frequency.
How will be the single line diagram of series trip HT breaker? how it works?