Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between machine and machine tool?
- 28 Answers
- 84338 Views
- I also Faced
- E-Mail Answers
Answer Posted / hamza shahid
MACHINE:-
A machine is a tool containing one or more parts that uses energy to perform an intended action. Machines are usually powered by mechanical, chemical, thermal, or electrical means, and are often motorized.
MACHINE TOOL:-
Machine tool is also the machine but it must have the following things.
1: Tool holding device.
2: Tool.
3: Remove the material in the form of chips.
| Is This Answer Correct ? | 14 Yes | 7 No |
Post New Answer View All Answers
Dear all, Will some one help me in this issue please? We are entering the Zero Stock Component in Maintenance Order, and we make a Check when the order creator is going to release system will appear Error, until he will not delete that zero stock components from the Maintenance order. but right now what the order creator is not releasing the order but he is going to save order, when's he save the order without release system will generate Reservation in the back ground, which should not happen for Zero Stock Components ? I need the way which we are doing in MB21, Reservation creation by thru Cost Center / WBS Element. At present if you run MB21 and you are going to issue the material system will not allow to generate the reservation if there are zero stock components in the list. please guide me for this issue ? Note : Simple what I need is I don't want to create any reservation thru maintenance order for the Zero Stock Components. Regards, Abdul Mujeeb
Explain the principle of Suizer Fuel oil injection pump
SOMEONE POST THE MODEL APTITUDE QUESTIONS FOR MRF TYRES PLz pLZ pLZ ..Very urgent
What is the Self & starter? what does it do in the in Genset
What is the difference between basic hole and basic shaft ?
What does angular momentum mean?
please sent last five years junior engineer mechnical question pappers
Explain the uses of windmill?
What are the causes of low compression in the main engine?
Who discovered non-newtonian fluids?
Can any one plz help me to find aptitude questions on UG.NX software??
CATIA:VARIATON IN SIZE AND PATTEREN
state the microstructure of annealed and normalized
What is the ratio of specific heat of air?
Which types of questions ask in pool campus pune in technical and aptitude test
