Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ayaz
DCS is distibution control system to monitor and measuring .
and ABB is manufacturer company this is largest one of them.
ABB is company name like yakogawa etc...
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
I have a Control VAlve having size of 2 ".Only the known parameter is Pressure drop . Its 2 Kg. Then How to calculate control valve sizing means Cv.
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
what is the process to make control schematic ?
1- Explain about HPM 2- What is the FSC and explain the configuration of FSC 3- explain the complete loop of vibration, how it works (field to control room) 4- What is the use of proxymitter? 5- During job your partner effected with H2S then what you have to do. 6- what type of gland packing uses when valve glind is leaking.
can you provide me full detail about instrumentation in ONGC??
what is function of SCADA , and how is it work, explain with difination
Describe how to use megger to measure the earth resistance and insulation resistance
Explain operation of Haskel pump.
Galvanizing.
Why thermo wells are used? What materials are used in thermo wells?
What is the calibration procedure of Drum level transmitter if range is 0 to -400 mmh2o in lab?
Question on maha cement
line up procedure for dp type flow transmitter?
What are the error values can accepted in flow transmitter calibration?could u give any formula for this?
Why use ball valves on Gas pipelines instead of gate & or globe valves...means basic diffrence or use of these valves..how designers knows this type of valve with rating is required...
