Answer Posted / anand
its difference of thermal energy between system and
surrounding
Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
How i injecter setting qsk series cummins engine and i can using click type torqurench or dial gauge type
Why consumption of lubricating oil is more in two-stroke cycle petrol engine than four-stroke cycle petrol engine ?
Why can't we use antifrictional bearing in place of journal bearing in a 660mw plant
1) Any pipe line working fluid may water / steam on it one manual isolation valve suppose one side of valve 6 kg/ cm^2 pressure (i.e. up stream) and other side is “ 0” kg/ cm^2 pressure(i.e. down stream) . So how much Tourqe required for opening the valve in terms of Newton force wheather normal man can open this valve. (for reference pipe nominal bore is 100 NB )
sir, i am completed in diplamo. can i join in iit, anna univercity as lateral entry. pls reply me sir.
What is gd&t?
Hello Friends I had my ONGC test today,but it was very bad.But I would give certain suggestions so that u may not face he problem which i had. Be thorough with Electrical Technology.Generators.motors stators etc.There are 5 questions on that. There were also good no.of questions from Hydraulic machine and Production technology. Then 3 from Strength of materials.And remember the dimensional quantities.
What is the remedy if due exchanging, valve broke out during engine running operation?
What will be the cause of the loose compression in a cylinder?
diffrence between fmea, pfmea,
Define Fluidised bed boiler ?
3x3x2.5 m room temperature increases by 20 deg cel in 24 hours by a lamp of 100 w. then tell the temperature of the filament
why constant pressure is consider for thermal diffusivity??
what is the thickness tolerances up to 32 mm
What the function of bye pass filter in DG.