if the supply voltage increased by N times, the x-section of
conductor will be.........
- 2 Answers
- 5309 Views
- APGenco, Electrical Tech, Ericsson, IES, Thirumalai Chemicals, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
X-sectional area depends only on current ,not voltage
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What are the insulation standerds for eg H clase and how many insulation standerds are there and its standerds??????
How to calculate total harmonic distortion level(THD) in VFD? and how can we reduce harmonics?
What are motor generator sets and explain the different ways the motor generator set can be used ?
what is harmonics? what are the factors it will depend upon
How to select the proper VSD to operate high inertial load
Give me the calculation steps to design an electromagnet to be work in 230V 50 Hz AC Supply. Also give force that is created by that electromagnet when it gets energized.
how to calculate micom relay earth falt time and current sertting
Why are the laminations insulated from each other?
Can anyone explain me about the capacitor calculation
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
how to avoid electrical shock how capacitor store charges wat are the speed control of induction motors state faradays law flemings left hand rule what is rotary converter wat is transmission and distribution what are the sources of energy abrevation of acb,vcb,sf6,igbt what is output equation of transformer which test copper iron and iron loss are calculated what is eddy current draw a single line diagram (10 marks) draw direct online starter(10 marks)
What is the end effect of linear induction motor ??
What is the selection process of breakers. Can any one please give a formulation on same?
What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer?
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
