Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / imran malik
SPC IS THE MOST IMPORTANT PART TO FIND THE CAUSE OF VARIATION IN THE PROCESS OF PRODUCTION BECAUSE SUBJECT MAY BE VARIATE IN LOWER AND UPPER CONTROL LIMITS .
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
The capacity of a domestic refrigerator is in the range of ?
Why is stress considered important in a shaft?
Differentiate between the uniform flow and non-uniform flow?
what's the difference between front and rear wheel drive?on what basis we choose the type of drive?
If 320 grade Gear oil is used in a reduction gear box,what can be themaximum operating temperature of the gear box?
What is fuel ratio ?
How the net work to drive a compressor and its volumetric efficiency behave with increase in clearance volume ?
Define heat transfer?
purpose of primary and secondary air? causes of smoke?
What color are thermal oil piping lines?
Define stanton number [st].
Why is nitrogen used in welding?
Does the rate increase by experience or number of years worked?
What is universal coupling?
WHAT IS PROTECTION AND INTERLOCK ROTECTION?
