What core magnetic balance test of transformer?
How to do this test in a three phase Star delta (star-LV,
Delta-HV) transformer?
How to measure and where to measure?
thanks and regards
Austin
- 22 Answers
- 93834 Views
- Neutech, Power Grid, TSSPDCL, I also Faced
- E-Mail Answers
Answer Posted / johny
I MEASURED 100KVA TRANSFORMER DELTA/STAR AND I APLYED VOLTAGE
RY 390 YB-321+ BR-72.8
YB 390 RY-221+BR-168.3 ( THIS VOLTAGE FROM DG)
BR 390 RY-77.6+YB314.6
IS IT CORRECT? PLS GIVE ME REPLY
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
how to choose cable size with respect to load? how to convert cable size in mm2 to sq.mm?
What is electrical cable termination
how to discharge 3 phase power factor correction capacitors
What is the accepted limit to increase the choosen transformer capacity over the load and why ?
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
why the difference arise between HT reading & LT reading (submeters fixed in complexes, apartments etc)if the power factos exceed from 0.9 to 1 can the ht meter reads fast?
How we can calculate the life of Lead acid battery
how to conduct dc resistance test for rotor of an alternator and how to measure the rotor dc resistance value theoritically?
Why are the laminations insulated from each other?
What is clock position of Transformer?what are the clock positions are there?and what is different of them?
What are the operation carried out in thermal power station?
Hi friends, i m electrical engineer i want a cdr for migration purpose so anybody have information about this then send me on jayesh_ee88@yahoo.com.please try to me
Hi, My plant daily consumption is calculated as 3.8MWH but my supplier has sanctioned an power of 2.6MW per day. how can i equal or distinguish this two factors
In both 600/1000 V cable and 450/750 V cable, we can supply 415 V. However for distribution, all utilities are using only 600/100 V instead of 450/750 V. What is the reason?
how to size H.T & L.T Panel ?
