why cant we use mV instead of mA?
- 12 Answers
- 20391 Views
- ABB, Power Grid, Qatar Gas, USW, Visa Steel, I also Faced
- E-Mail Answers
Answer Posted / delta_v
That's due to voltage drop :)
As simple as that...
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is zero elevation and zero suppression?
send me model hpcl questions pleas..........my mail id mohideen.dharvesh@gmail.com
what is the working principal of pribe
Coal mill Instruments Equipments for cement plant And process diagram ?
which type of signal used in instrument?
Make Heater Process Logic.
Can Any body tell me how to check Modbus Settings in ER300N L&T trivector meter?
Is there any relation between Artificial Intelligence and Instrumentation?
how many types of spped sensors n vibration sensors?their basic principle n connection?
What is the use of each wire in three wire RTD
sir i m preparing for BARC but i am not getting any papers to prepare for this exam so please send me some sample papers to my i.d for the preparation of barc.
How to calibrate level transmitter with use of HART?
how to design orifice plate?what is the equation?
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ
