What is the difference between CRNO and CRGO in an
transformer and what is the advantages of these two.
- 13 Answers
- 68761 Views
- Anchor, CIL, ETA, Kirloskar, I also Faced
- E-Mail Answers
Answer Posted / hakim
CRGO IS COLD ROLLED GRAIN ORIENTED AND CRNO IS COLLED
ROLLED NON GRAIN ORIENTED STEEL ,BOTH ARE ELECTRICAL STEEL.
CRGO USED IN TRANSEFORMER AND CRNO USED IN MOTOR WINDING,IN
COMPRESSER .
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
how we calculate the short circuit capacity of the busbar in LV & HT?
i m in need of current rating chart of heavy duty pvc/xlpe, cu/al cables. can somebody provide me? if yes, plz send me at ashish_patel111@yahoo.com
High speed earth switch operation with diagram
In a flange coupling, the flange bolts are designed for
in a silicon diode we can measure .7v in a voltmeter.but why we can't use this voltage for using?
what are the range of memory address in plc for L&T lx7 4A
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
is it possible to start a motor in felid connected to a remote mcc
What will be the effect if I use inverter as UPS mood?
How can you calculate the size of the down conductor cable for the lightning protection system. Is 70mm2 cable can replace 95mm 2 bare copper cable when the copper tape size is 25Wx3 thk mm.
would you please give me any idea about the BARC interview question on electrical? i have an interview on 1st july.....plz hlp me.......its urgent......
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer
why normally Generator rating are between 11Kv to 22Kv?
Why is back emf used for a DC motor? Highlight its significance.
