Answer Posted / yousuf
p&id means piping and instrumentation diagram. it shows how
the instruments are interconnected in the process.
Is This Answer Correct ? | 22 Yes | 2 No |
Post New Answer View All Answers
How do you identify an orifice in the pipeline?
Explain why plc require in analog input 4-20amp & 0-10 volt?
for oil & gas industries which zone is normally preferred? why? give its example?
Why do we floating DC in DC system.
1.can you use SCADA instead of DCS,DCS instead SCADA 2.Difference between DCS and PLC,can their role be reversed i.e. role interchange 3.Difference between RTU and PLC
In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.
what is the difference between profibus and controlnet networking.
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
where uses EXe /EXd/Exo/Exn/Exp/Exq/EXia
how u choose thermowell lenght n pnumatic C/v size?
In which principles tx ,pressure gauge,Temp gauge,control valve works?
how to calibrate electro pneumatic positioner 8013 mil controls ltd ?gsr
What are the types of control valves available
What is hp & mp seperator .& what is its working principle ?
i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......