What should be the earthing resistance of an industrial
substation and also What should be the house hold earthing
resistance?
Answer Posted / kaviraj
if v want to gnd that current to the earth y v want to use a resistance better v can use a wire with 0 resistance so all the fault currents will be by passed.
Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
hello everybody. what does an abnormal stator winding impedance or dc resistance show? thanx
What is the difference in calculating size of AC cables compared to calculating size of DC Cables? Usually DC Cables are larger than AC Cables although they have the same ampacity. Why is it?
what is the relative size of single and three phase?
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
how to i get B licence,i am completed BE electircal and electronics engineering.i want to konw the proceduure to get b licence
75 kw motor take 45 amp in no load delta in star 10 amp but in load it will take 160 amp but IR velue of winding above 500 at 1kw ph to earth and ph to ph. what problem it should be?
What is lighting kitts.
why do we use spark detector inside the slip ring brush compartment 0ona slip ring induction motor?
how to find the resistance and gap volatage of the diode??
EXPLAIN WHY THE SURGE CURRENT RATING OF AN MCCB OR CIRCUIT BREAKER DECREASES WITH INCREASE IN THE RATING OF MCCB OR CIRCUIT BREAKER.
WTA used cb?
Why we are use dol starter up to 10 hp
what is the best transformer oil breakdown voltage?
if we apply 1000ADC instead of 100ADC or We apply 50ADC instead of 100ADC,What will be happened in the test result value.Pl explain
What does the term supermesh means?