On what basis no of earth pits are to be decided either for
transformers or for equipment?
- 8 Answers
- 20604 Views
- BEL, Reliance, I also Faced
- E-Mail Answers
Answer Posted / kartik
No of Earthing pits for a equipment depends upon components
of equipments prone to flow of fault current during
abnormal condition.Say for transformer, metal body &
neutral may carry fault current.So 2 nos pits for
transformer is required.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is the easiest method of short circuit current calculation ? pls. derive with a mathematical example in real life application.
What is the permissible limit of shaft voltage for 6.6 KV motors ? Why? Is there any standard is available?
What is the effect on 3phase induction motor if current setting knob of DOL kept at minimum current?
what are the effects when a salient pole alternator is run at high speed like 3000 r.p.m?
HOW TO SET THE EARTH FAULT SETTINGS IN ACB????????????
What is the phase relationship between the primary and secondary voltages of a transformer?
What is the de rating factor of cable? What is the importance of the de rating factor in cable select
How To increase Knowledge Of boliler regarding To Only Electrical Field..
what is Fan Control Cubicle
for what voltage will reactive power be largest in 380 kv line : a) 375kv b)380kv c)385kv
how is the magnetic current test is different in delta-star and delta delta transformer.
Define norton equivalent circuit?
In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is
How generator NPS(NEGATIVE PHASE SEQUENCE TEST)TEST WAS DONE? PROCEDURE WITH DETAILS?
The efficiency of a 100kva transformer is 0.98 at full load as well as half load , for this transformer what is the Copper loss at full load ?
