What is the difference between AC Drives and DC Drives?
- 14 Answers
- 91453 Views
- College School Exams Tests, La-Gajjar Machineries, LG, Schneider, SMEL, I also Faced
- E-Mail Answers
Answer Posted / sridhar
1.AC DRIVE main purpose to used for speed control
application ,to changing the frequncy(fz).
mainly ac drive used for conveyor.
| Is This Answer Correct ? | 12 Yes | 6 No |
Post New Answer View All Answers
what is the formula for calculating the phase clerance between two phases and phase to earth how to calculate the cable for a motor
why should the primary of transformer be connected in delta in a heat run test?
what is the current setting for different relay protection for transformer .
HOW TO CALCULATE S/C,O/C,E/F OF ACB.
where the lexical paramater will use in fron end?
Why cables and busbar both needed in LT Panels?
What is meant by stator?
i had aplied Hindustan Petroleum corporation limited for the post of maintenance technician -Electrical,i want model questions,if anybody have please send it or please advice?
how to read idmt curva
A 50Hz,4-pole,3-phase,star-connected synchronous motor has a synchronous reactance of 12ohmsper phase and negligible armature resistances.the excitation is such as to give an open-circuit voltage of 13.2kilovolt.the motor is connected to 115kilovolt, 50hertz supplying. what maximum load can be the motor torque,line current and power factor?
what is difference between cpp electrical system and refinery electrical system
What is the difference between solid grounding and impedance grounding?
current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer
what is reactive power?, why its measured in VA ? is it transient behavior of system?
Thermal withstand capability under full short circuit conditions, in terms of number of times of occurrence of short circuit and corresponding anticipated percentage reduction in transformer life.
