what is tan delta measurement?..... why that terminal is
earthed.....?
Answer Posted / shashank vyas
tan delta testing is done to measure the dielectric
strength of the insulation.........n to determine whether
the insulation is in healthy condition or not.
if the new value matches with old one ,than insulation is in
healthy condition
generally value of tan delta is .007
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
sir i applied for hpcl(electrical).i want to know from which subjects most of the technical que will b asked.and pattern of the written test.pls help me
what is effect of leading power facter on the system and billing
What do you understand by oldham's coupling ?
sir, i'm preparing for hpcl exam officer trainee pls tell me how the exam ques paper pls pls
How to discuss the phase shift of transformer considering open delta?
what could be the RMS value and average value of a 4 phase sine wave?
what is meant by star/delta voltages as 440/220 in a 3 phase induction motor, and why it should be connected on STAR IN 3 PHASE SUPPLY
Define delay time.
what is formula for calculate thermal overload in new numiricalrelay( not in bimetal relay)?
What is knee point voltage of transformer?
What is relation between transmission lines & Communication lines ?
what is the mechanical safety of DG ?
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
what is the difference between the voltage of 5 volts capacitor and and 5volts battery?
how we findout a ignater is faulty or not?