Interested to Buy Any Domain ? << Click Here >> for more details...
why 400Hz is used for aircraft systems ?
- 14 Answers
- 55653 Views
- Cabin Crew, Jet Airways, I also Faced
- E-Mail Answers
Answer Posted / guest
because using higher frequency makes the trnsfrmr size small.
| Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
What is control system?
How to calculate the copper in HT motors if KW, RPM & Voltage is given
can i use 4 number of circuit breaker as single phase manual change over switch? if yes then how plz also send ckt diagram at nazimzamurad@gmail.com
We have studied about many techniques for finding the stability of system, ROOT LOCUS, ROUTH, BODE PLOT, POLER PLOT etc. In these which is used where. what are the difference among them... PLZ tell me.......
1. A bomber drops a bomb from an aircraft flying at 2000 km/hr. at an altitude of 7km. The speed at which the bomb will strike the earth would be
why Lightening Arrester Probe sharp at Top of telecom tower.
Diagram and details of polarity test for Current Transformer 11kv 400/200/100/1A
What are the causes of unbalanced current on 34.5kv feeder Ia=0.05,Ib= 0.25, Ic=0.15 and In=0.27 prior to tripping current are balance?
what parameters should we check to reduce the power bill
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
When we connect the large capacitor bank in series ?
. What is Electrical Life & Mechanical Life of Circuit Breaker? 2. What is Electrial Life & Mechanical Life of Magnetic Contactor? 3. What is RCD, RCCB & RCBO? 4. What is the Between defferance of RCD, RCCB & RCBO?
what are the things that can cause a three phase motor to crawl?
Why does increasing the magnetic flux in the main field of a d.c motor cause the armature current to reduce??
We are planning to synchronized DG's with our captive plant in the event of black start of plant, but before sync we checked voltage of DG with our plant voltage and it varies from 5 V to 450 V. So in this condition how we can sync DG with plant ?
