Answer Posted / sujol
For trnafomer cooling mostly Crude oil is used.
Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
How to Decide the Location of Earth pit for Compressor in Oil Depo? and How to measure the resistance of earth pit Pls explain me with the help of Circuit Diagram?
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
Its possible to use 3core 2R of 240 sq.mm cable for 3phases & separely 50sq.mm 3core cable fully for Neutral for connection of PCC to MCC 3ph..4wire system?
Why reactors use before incoming of ac vvfd drive?
during installation time of transformer and alternator which points we have to observed?
what is the difference between droop mode and ischnorous mode in thermal powerplant?
Benifits of 3ph 4 wire metering over 3ph 3 wire
if 12v battery get discharged for 2 months after if we put charge it will charge again?how much time it will take to charge?
how to avoid Saturation in C.T?
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
Tell me the reason of connecting domestic t/f primary in star or delta,and also secondary side.
what is the ground fault relay,which purpose it will be use,clearly tell me plz
how braking & making capacity of circuit breaker is calculated?
How you calculate the repturing capacity of a HRC fuse