Interested to Buy Any Domain ? << Click Here >> for more details...
Why is DC use instead of AC for protection and control
circuits?
- 4 Answers
- 8999 Views
- I also Faced
- E-Mail Answers
Answer Posted / tahirwasim10
Protection of a system is very necessary factor which
require fast response during faults. For protection of a
power system the D.C used instead of A.C because there are
many problems in A.C ( quantities variation problems, slow
response problems etc).
| Is This Answer Correct ? | 2 Yes | 4 No |
Post New Answer View All Answers
what is the mechanical safety of DG ?
What is power factor why we should maintain the power factor unless what will happen
How to Preparation of online test
Why the moulded plug comes with domestic appliances instead of assembled plug like anchor, Vinay 5/15 A.
Why i receive the GCU fault in my DG Sychronization panel . what all the factors considered for this fault .
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
how technical is calculated in 11kv line and lt line
1.Z transform always lies around ? a) origin b) pole c) zero d) z=1. Multiples Mcqs which is bother me can’t find answers on internet. Some help required with little explanation . Note: this is not homework or related to any test. Thanks
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
Where should the lighting arrestor be placed in distribution lines?
How to checked frequency drive output voltages?
Can anyone provide with a SLD for HT panel installation for a 33KV line and distribution end has three 1.5MV transformers. Is it suitable to use OCB or VCB and also provide me the suitable rating and its connection diagram.
how the B-H loop obtain under the static condition
how the CT and PT is connected in the circuit during testing of transformer explain with diagram
how give earthing conection to household equipment?
