Interested to Buy Any Domain ? << Click Here >> for more details...
1.In modal analysis ,we can give damping or not?
2.draw goodman's rankine fatigue curve?
3.write down goodman's rankine fatigue equation?
4.IN structural analysis ,out of so many stresses,why
von-mises stress are chosen?
- 1 Answers
- 11068 Views
- Infotech, I also Faced
- E-Mail Answers
Answer Posted / zoom
Q1: In general damped modal analysis is not carried out.
Because modes will be complex. However, it is possible to
find out damped natural frequencies/shapes. But damping
matrix need to be obtained, which is impossible for general
structural components. But modal analysis that is offered in
most of the general purpose FE Codes neglects damping.
Q3 & Q4 : Refer Machine Design by shigley.
Q4: In multi-axial state of stress one cannot know failure
can occur because of which stress (out of 6 stresses). Hence
theories of failure have been developed. When we compare
Von-mises Stress with material strength we are actual using
Distortion energy theory for the design. Which is in very
good agreement with experiments for ductile materials.
| Is This Answer Correct ? | 12 Yes | 1 No |
Post New Answer View All Answers
Please tell about the water type h.v.a.c with it's cycle and functions of each parts ?show me how talented u r?
Why are lng pipes curved?
Why is over-pressurizing an air conditioning system bad?
Hello Friends I had my ONGC test today,but it was very bad.But I would give certain suggestions so that u may not face he problem which i had. Be thorough with Electrical Technology.Generators.motors stators etc.There are 5 questions on that. There were also good no.of questions from Hydraulic machine and Production technology. Then 3 from Strength of materials.And remember the dimensional quantities.
As a foreign applicant, what do you understand about our company before sending your application CV for consideration?
Metals, in general are of low strength and do not possess required physio-chemical and technological properties for a definite purpose. Alloys are therefore more than metals alone. Discuss the arrangement of atoms and structures of alloys.
I got i20 for university of bridgeport,university of new heaven and eastern michigan university.Please tell me visa success rate for these universities.And I want to go to Connecticut.At that place two universities are avaliable one is new heaven and the another one is bridgeport.Which is the best? Please give reply as early as possible.
what are the activities to be done after a steam turbine trips?
what is lube oil cons./hours in diesel engine ???
what is the magnetic (electric) center)
"In refrigeration, why during operations is running low pressure at the suction side?"
sir/ madam i m apearing to rrb bhubaneswar for entrans exam please i want a help to get thruogh this
What is the thermal efficiency of a diesel engine?
When did you decide to become and mechanical engineer and why?
please msg me tecnical question of hpcl
